Don’t leave the drill press running or plugged in after you’re done using it.Take the workpiece off the table and remove the swarf or other remnants of the drilling process.The tenth step is to stop the drill press and take the chuck key out of the drill bit’s chuck.If you want to drill a hole to a certain depth, number nine is to stop the drill press and lift the quill.Start drilling by pushing the start button or lifting the lever on the drill press.After positioning the drill bit, slowly lower the quill until it touches the workpiece.Six, power up the drill and center the drill bit on the spot you marked.As a result, you may be sure that every hole you drill will be exactly the right depth. The fifth step is to set the depth stop at the level you want to drill to.Place the drill bit in the chuck and secure it using the chuck key. ![]() Fourth, be sure the drill bit you choose is suitable for the material and size of the hole you want to make.Take precautions to ensure that the workpiece will not move while being drilled. Next, clamps or other methods for holding the workpiece to the table should be used.To learn what optimum speeds are for your device, read the instructions. Second, you should adjust the drill’s speed to suit the material you’re drilling. ![]() The legs, the top, the column, the table, the spindle, the chuck, and the quill all fall within this category.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |